Analytical method
Amino acid analysis (AAA) on a peptide COA: composition, content and blind spots
By Vitality Chems · Published · updated · vendor-authored explanatory note
Short answer
Amino acid analysis hydrolyses a peptide to free amino acids, separates them, and compares the residue ratios to the theoretical composition of the intended sequence. It is a classical identity and peptide-content method (ICH Q6B; USP general chapter 1055) and does not, by itself, prove the order of residues. Acid hydrolysis typically destroys tryptophan, partially destroys cysteine and converts asparagine and glutamine to aspartic and glutamic acid, so those residues need a modified method or a different test. LC-MS remains the usual way to confirm the intact mass and, with fragmentation, the sequence order.
Catalog materials discussed on this page
| Question | AAA result | Better companion test |
|---|---|---|
| Do the residue ratios match the intended formula? | Yes, for residues that survive hydrolysis | LC-MS intact mass |
| Is the residue order correct? | No; AAA is order-blind | MS/MS or Edman sequencing |
| How much of the powder is peptide? | A content figure can be calculated from recovered residues | Net peptide content / nitrogen or AAA content |
| Are Trp or Cys present as expected? | Only with a modified hydrolysis or a specific assay | Intact LC-MS, or a dedicated Trp/Cys method |
| Are D-residues present? | Standard AAA is not a chiral method unless a chiral variant is used | Chiral AAA or a method that resolves diastereomers |
| Are Asn and Gln intact? | No; they appear as Asx and Glx after hydrolysis | LC-MS (deamidation is +0.984 Da) |
| Are Ser and Thr fully recovered? | Partly destroyed; often corrected or extrapolated | Time-course hydrolysis or LC-MS |
How the measurement is made
The usual workflow is hydrolysis (commonly 6 M hydrochloric acid, heat, a defined time), then chromatographic separation of the free amino acids with UV, fluorescence or mass detection after derivatization. The laboratory reports micromoles of each residue per milligram of sample, or a normalized ratio, and compares that profile with the theoretical composition.
Automatic recording of amino-acid chromatograms goes back to Spackman, Stein and Moore (1958). Current official descriptions for biotechnology-derived articles include USP general chapter 1055 and the identity/content expectations in ICH Q6B. A certificate should cite the hydrolysis conditions and the detection method, not only 'AAA: conforms'.
Known blind spots
Standard acid hydrolysis converts asparagine to aspartic acid and glutamine to glutamic acid, so those pairs are usually reported together. Tryptophan is largely destroyed, and cysteine is recovered poorly unless it is oxidized or otherwise protected before hydrolysis. A peptide whose identity hangs on those residues needs a modified hydrolysis, a separate assay, or an intact-mass measurement.
Because the chain is broken, two sequence isomers with the same residue composition give the same AAA profile. That is why this site treats LC-MS identity (and, when needed, fragmentation or a chromatographic separation of isomers) as the test that confirms which molecule is in the vial. AAA is still useful: it is independent of UV chromatogram area, it can support a peptide-content number, and a clearly wrong ratio is a reason to reject a lot.
Worked example: the expected AAA profile of BPC-157
BPC-157 (GEPPPGKPADDAGLV, 15 residues) is a convenient example because it has no tryptophan, cysteine or methionine. After acid hydrolysis its theoretical profile is Pro 4, Gly 3, Ala 2, Asx 2, Glx 1, Lys 1, Leu 1, Val 1. Asx is reported because the two aspartates cannot be told apart from any asparagine after hydrolysis; Glx likewise for the single glutamate.
A laboratory normalises the recovered amounts to stable residues (often Ala, Leu or Gly) and reports the ratios next to the theoretical values. Ratios within roughly ±10% of theory for well-recovered residues are generally read as consistent with the intended composition; the certificate should say which acceptance range the laboratory applied.
- Proline gives a weaker signal with some derivatisation chemistries (it is a secondary amine), so its ratio is read with the method in mind.
- Valine and isoleucine next to each other hydrolyse slowly, so their recovery can read low after a short hydrolysis.
- Serine and threonine are partly destroyed during hydrolysis; laboratories often correct them or extrapolate to zero time.
From recovered residues to a peptide-content figure
AAA can also estimate how much of a weighed powder is peptide. The laboratory converts recovered nanomoles of well-behaved residues into nanomoles of peptide (dividing by how many of that residue the sequence contains), multiplies by the peptide's molecular weight, and divides by the weighed sample mass. The result is a mass fraction, the same idea as net peptide content.
Example arithmetic, with round numbers chosen for illustration and not taken from any lot: if a 1.000 mg sample of BPC-157 powder yields, averaged across Ala, Leu and Val, 600 nmol of peptide, then 600 nmol × 1419.5 g/mol = 0.852 mg of peptide, a mass fraction of about 85% w/w. The remainder is typically water, counter-ions and residual solvent, which Karl Fischer, ion chromatography and GC address separately.
Scope of this page
This is a method note for reading an amino-acid-analysis field on a laboratory certificate. It is not a protocol for running the hydrolysis, and it is not guidance for use in people or animals. Materials from Vitality Chems are for research use only.
Frequently asked
Does amino acid analysis prove peptide sequence?
No. It compares residue ratios with the intended composition. It does not establish the order of residues. Intact mass and fragmentation (or another sequencing method) are needed for order.
Why are tryptophan and cysteine often missing or low?
Standard acid hydrolysis destroys most tryptophan and recovers cysteine poorly. A modified hydrolysis or a separate assay is required if those residues matter for the identity check.
Can AAA replace LC-MS on a peptide COA?
It should not. The two tests answer different questions. LC-MS confirms the intact molecule and can show mass shifts from deletions or modifications. AAA checks composition and can support a content figure.
What do Asx and Glx mean on an amino acid analysis report?
Asx is aspartic acid plus asparagine, and Glx is glutamic acid plus glutamine. Acid hydrolysis converts the amides to the acids, so the two members of each pair are reported together.
How is peptide content calculated from amino acid analysis?
Recovered nanomoles of stable residues are converted to nanomoles of peptide, multiplied by the molecular weight, and divided by the weighed sample mass. The result is the peptide mass fraction of the powder.
What AAA ratios should BPC-157 show?
Theoretical composition after hydrolysis: Pro 4, Gly 3, Ala 2, Asx 2, Glx 1, Lys 1, Leu 1, Val 1. The certificate should list the observed ratios next to these values and state its acceptance range.
Which documents describe amino acid analysis?
ICH Q6B discusses amino acid analysis as an identity and substance-content method for peptides and proteins. USP general chapter 1055 describes the technique. The original automated chromatography is Spackman, Stein and Moore, Analytical Chemistry, 1958.
Related on Vitality Chems
- HPLC vs LC-MS what each technique proves.
- BPC-157 CAS, MW and sequence the worked example's identity data.
- HPLC purity vs net peptide content how content figures relate to purity.
- Look up a COA by lot number open the report for your vial.
- Peptide COA testing standards the panel of tests a certificate can include.
- How to read a peptide COA 10-point certificate checklist.
- Karl Fischer water content on a peptide COA another content-related measurement.
References
- ICH Q6B Specifications: Test Procedures and Acceptance Criteria for Biotechnological/Biological ProductsIncludes amino acid analysis among identity and substance-content tests.
- USP-NF General Chapter 1055, Biotechnology-Derived Articles — Amino Acid Analysis (official text)Compendial description of amino acid analysis.
- Spackman DH, Stein WH, Moore S. Automatic recording apparatus for use in the chromatography of amino acids. Anal Chem. 1958The classical automated amino-acid analyser.