Analytical method
Karl Fischer water content on a peptide certificate of analysis
By Vitality Chems · Published · updated · vendor-authored explanatory note
Short answer
Karl Fischer titration measures water in a sample. On a lyophilized peptide certificate it is usually reported as percent water (weight/weight). It is not HPLC purity and it is not net peptide content: a high HPLC area-percent figure can still sit beside several percent water, because water is not a peptide impurity peak. The water figure is one input, with the counter-ion, when a laboratory converts a weighed mass into peptide mass. Official methods include USP general chapter 921 and ISO 760.
Lot-documented research materials
Catalog pages show the price and any published third-party lab report; otherwise a lab report is available on request. Browse the catalog →
| Result | What it measures | What it does not measure |
|---|---|---|
| Karl Fischer water | Water in the weighed sample, usually % w/w | Peptide identity, HPLC purity, or residual organic solvent |
| HPLC area-percent purity | Share of the UV peak area in the main peptide peak | Water, most counter-ions, or silent solvents |
| Net peptide content | Fraction of the powder that is peptide, not water or counter-ion | Whether the peptide peak is the correct sequence |
| Residual solvents (ICH Q3C) | Named organic solvents remaining from manufacture | Water; water is tested separately |
What the method actually titrates
Karl Fischer titration is a stoichiometric reaction of water with iodine and sulfur dioxide in the presence of a base and an alcohol. The laboratory stops the titration when the iodine is no longer consumed, and reports the water found as a mass fraction of the sample taken. Coulometric Karl Fischer is often used at low water levels; volumetric Karl Fischer is used when more water is present. Either can be valid when the method is described and the sample size is adequate.
Lyophilized peptides are hygroscopic. The result depends on how the vial was opened, how quickly the aliquot was weighed, and whether the solid was handled under dry gas. A certificate should say Karl Fischer (or an equivalent official method) and give the result with units, not only a pass/fail.
How to read the number next to HPLC purity
HPLC area-percent purity ignores water because water has no UV peak in a typical peptide chromatogram. Two lots can both be reported as 98% HPLC purity and still differ in water content by several percent, which changes how much peptide is in a weighed milligram. Net peptide content, when it is reported, already folds in water and counter-ions; Karl Fischer is the direct water measurement behind that figure or a check on it.
A companion page on this site covers HPLC purity versus net peptide content. Use this page for the water method itself, and that page for the arithmetic that connects the two results.
- Confirm the method is Karl Fischer or a cited official chapter, not a loss-on-drying figure presented as water.
- Read the unit (% w/w, or µg/mg) and the sample size.
- Loss on drying can include residual solvent and other volatiles, so it is not a synonym for Karl Fischer water.
- If net peptide content is also reported, the water figure should be consistent with that story; a large unexplained gap is a reason to ask the laboratory.
Scope of this page
This is a method note for reading a water-content field on a laboratory certificate. It is not a protocol for running the titration, and it does not tell anyone how to prepare or use a peptide. Materials from Vitality Chems are for research use only.
Frequently asked
Is Karl Fischer water the same as HPLC purity?
No. Karl Fischer measures water in the weighed powder. HPLC area-percent purity measures the share of the UV chromatogram in the main peptide peak and is blind to water.
Is Karl Fischer the same as net peptide content?
No. Net peptide content is the fraction of the powder that is peptide rather than water and counter-ions. Karl Fischer is the direct water measurement. Both can appear on the same certificate.
Why can two lots with the same HPLC purity have different water content?
Water does not appear as a UV peak, so it does not change the area-percent purity figure. Lyophilized cakes also pick up moisture differently depending on handling and stoppering.
Which official methods describe Karl Fischer water determination?
USP general chapter 921 and ISO 760 are the methods most often cited on certificates. The official text lives in those standards; this page only explains how to read a reported result.
Related on Vitality Chems
- HPLC-documented research materials HPLC purity vs net peptide content, including water and counter-ions.
- HPLC area-percent purity what the purity percentage actually is.
- TFA vs acetate peptide salts the other large non-peptide mass on many lots.
- Residual solvents on a peptide COA organic solvents, tested separately from water.
- Synthetic peptide impurities process impurities, TFA, water and solvents together.
- Lyophilized peptide storage and handling moisture uptake after a vial is opened.
References
- USP-NF General Chapter 921, Water Determination (official text)Compendial Karl Fischer and related water-determination procedures.
- ISO 760:1978, Determination of water — Karl Fischer methodInternational standard for the Karl Fischer determination of water.